Led Neon Handle
2010
![]() HYPER GREEN LED NEON GLOW DOOR HANDLE / VENT ACCENT KIT US $11.99
|
![]() HYPER GREEN LED NEON GLOW DOOR HANDLE / VENT ACCENT KIT US $11.99
|
| Powered by phpBay Pro |

Where would you connect a switch panel?
Fuse box, Add-a-circut, battery?
This is the switch panel that im thinking about
http://www.urban-neon-car-lights.com/images/D/SWITCH%20PLATE_EFFECT.jpg
also. im thinking about using all the switches, will doing so do anything? because those 5 wires turn into 1 wire...which then connect to the 12v...would it be too much power for the panel to handle
these is what im thinking about put in them
interior led lights
bonnet washer led
underglow lights
radar detector
gps
Assuming the power ratings in watt and dividing them by the voltage (12V) provides single current ratings in amperes:
1) 3W --> 0.25A
2) 3W --> 0.25A
3) 12W --> 1A
4) 48W --> 4A
5) 12W --> 1A
(You can improve this estimate by using the ACTUAL ratings taken from single product data sheets, but there shouldn't be much difference.)
Summing all amps, you get 6.5A, so you can hook it downstream of a dedicated 7.5 or 8A fuse or on an already used one with sufficient margin in terms of A. Depending on whether the equipment has to operate with ignition off, choose the fuse accordingly.
This shouldn't stress the system at all, provided you don't leave everything switched on for hours on end with the engine off.
| Powered by phpBay Pro |



















Comment