Kit Keyless Remotes
2010
| Powered by phpBay Pro |
98' 3.8L mustang keyless entry?
My boyfriend owns a 1998 3.8L V6 mustang and I want to order him the keyless entry but he says that the wires are already installed on the car, so do I still need the whole Kit, or just the remotes? Should I just order the whole kit just to be on the safe side?
♥ Thanks!♥
All you need are the remotes, the 98 Mustang came standard with remote keyless entry. You will need to get the right Ford remotes, aftermarket ones will not work with the factory system. You can usually get them on E-bay cheap, below I have included the Ford instructions to program the new remotes.
Programming, Electronic Door Lock Control Processor
NOTE: The remote keyless entry module erases all previous keyless entry remote transmitters (15K601) from memory when the keyless entry remote transmitters are programmed or reprogrammed. The remote keyless entry module can store up to fourkeyless entry remote transmitters in memory. All keyless entry remote transmitters must be programmed (reprogrammed) at the same time.
To program (or reprogram) keyless entry remote transmitter into the remote keyless entry module, perform the following steps:
Turn ignition switch to RUN or ACC position and momentarily short the two terminals of the Program Connector (two-pin connector next to the remote keyless entry module. Remove LH luggage compartment trim panel to reach the connector). Both doors should lock and then unlock. Remove shorting pin.
Press any button on keyless entry remote transmitter . All front doors should lock and then unlock to verify that keyless entry remote transmitter has been programmed.
If door locks do not respond, press button again (up to three times maximum with the same keyless entry remote transmitter ). If door locks still fail to respond, go to Pinpoint Test A.
Repeat Step 2 to program additional keyless entry remote transmitters into the remote keyless entry module (up to a maximum of four keyless entry remote transmitters ).
Turn ignition switch OFF. Both doors should lock and then unlock.
Check operation.
| Powered by phpBay Pro |
Comment